Introduction

The KDT2000 Drop Tester is designed to simulate the drops and mechanical hazards that occur in distribution. It is especially suited to very large, heavy payloads which cannot be tested on conventional drop test machines.

The KDT2000 consists of a quick-release mechanism, lifting ring, and foot-switch for initiating the drop. Straps wrapped around the test item form a sling that attached to the O type ring, which is placed in the latch jaws of the quick-release mechanism. The quick-release mechanism and test package are then lifted to a pre-determined height by a fork-lift, winch, or other lifting device (not included). Press the Remote Foot-switch causing the latch jaws to open and the package to fall.

Technical Specification

Weight Capacity: 200kg～1500kg

Power Required: AC220V / 50Hz ( or according to customer’s need)

Compressed Air: 0.5Mpa～0.7Mpa

Lifting Device: Customer Supplied

Weight of KDT2000 : 11kg ( excluding foot-switch, which is 5kg)

Size of KDT2000: 345 x 235 x 145 mm

Size of foot-switch: 270 x 200 x220 mm ( Lx D x H)

Simulation Animatronic Customer Triceratops are covered with air bubble film before put them into the wooden case,which not only has good shock absorption, impact resistance, heat sealing and also has the advantages of nontoxic, odorless,moisture corrosion, good transparency etc